Product code: ECK-BEY-027apartment entrance door
Şev Diagonal-Cut Anthracite Steel Door
Şev sets a wide white diagonal band across an anthracite ground textured with fine horizontal lines, running from the upper left corner to the lower right in a single sharp sweep. A slim stainless bar handle follows the same angle, laid directly over the band.
- Colour
- Antrasit
- Door leaf
- Single leaf
- Glazing
- No
- Hardware
- İnox detay
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
Splitting light and dark along a diagonal rather than a straight edge gives the leaf an unusual, slightly off-balance character. The white band reads like a trail of light cutting through the dark ground, which is why Şev works where a building's joinery or frontage is already dark and the aim is to keep the door dark too, without the door disappearing into it.
How steep the band sits depends on the proportion of the opening: a tall, narrow leaf steepens the angle, a wide one flattens it. On both ends the white holds the same clarity against the dark ground by day or under artificial light.
The white diagonal also draws the eye downward along its length, which makes a narrow entrance read taller than its actual proportions suggest.
- White diagonal band on a dark ground
- Horizontal-line anthracite texture
- Stainless bar handle set along the diagonal
- Single leaf, no glazing
Attributes
| Item | Value |
|---|---|
| Product code | ECK-BEY-027 |
| Colour | Antrasit |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | İnox detay |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Şev Diagonal-Cut Anthracite Steel Door?
Şev cuts a wide white band diagonally across an anthracite ground textured in fine horizontal lines, running from one corner to the other in a single sharp sweep. The off-axis cut gives the leaf a slightly unbalanced, deliberately unusual character rather than the symmetry most models in the group carry.
Can the Şev Diagonal-Cut Anthracite Steel Door be made to a custom size?
Yes. The leaf and frame are produced to your door opening, and the diagonal is redrawn to the new proportion, steepening on a tall narrow leaf and flattening on a wide one. Measure the opening from inside the frame and send the figures across; we take a further on-site measurement before manufacture.
Which group does the Şev Diagonal-Cut Anthracite Steel Door belong to?
Şev sits in the apartment entrance door group, finished in anthracite with a single, unglazed leaf and stainless detailing. Body, insulation and lock hardware are shared across the group; what changes from one model to the next is the surface pattern and the leaf layout. Weigh the choice against the light your entrance gets.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.