Product code: ECK-LMK-017Laminoks steel door
Ayça Curved Timber Panel Laminoks Steel Door
Ayça leaves the left edge of its timber panel curved rather than straight; the curve opens from top to bottom, with the anthracite ground falling outside that line.
- Colour
- Ahşap tonu
- Surface finish
- Laminoks
- Hardware
- Bar kulp, Mermer eşik
- Door frame inner size
- 90 x 200 cm
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
It is the only curve in the range; every other model is built from straight or angled lines. The curve softens the leaf, and against a landing full of geometric pattern it reads as a deliberate contrast.
A thin timber strip runs just beside the curve, repeating it and making the line read more clearly; a single curved edge on its own would not carry as far.
The panel's horizontal line texture meets the curve at an angle, and the lines shorten as they near it, which is what signals the direction the curve is moving in.
The curve's sweep is not fixed: on a wide leaf it opens out, on a narrow one it steepens, and either way it stops short of the corner so a margin is always left at the edge.
- Anthracite Laminoks ground
- Curved-edge timber panel
- Horizontal line texture
- Thin timber strip along the curve
- Black bar handle
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LMK-017 |
| Colour | Ahşap tonu |
| Surface finish | Laminoks |
| Hardware | Bar kulp, Mermer eşik |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Ayça Curved Timber Panel Laminoks Steel Door?
Ayça leaves the left edge of its timber panel curved, opening from top to bottom against an anthracite ground that falls outside the line. It is the only curve in the range, since every other model is built from straight or angled lines, and that softness reads as a deliberate contrast against a geometric landing.
Can the Ayça Curved Timber Panel Laminoks Steel Door be made to measure?
Ayça is prepared to a standard frame opening as stock. Where your opening differs, the same ground and curved panel carry through to a made-to-measure leaf, with the sweep of the curve adjusted to the width. Send the width and height from inside the frame; the opening is checked again on site before fitting.
Which group does the Ayça Curved Timber Panel Laminoks Steel Door belong to?
Ayça stands in the Laminoks steel door group, in a timber tone with a bar handle and a marble threshold. Body, insulation and lock hardware are shared across the group, and the facing is what separates one model from the next, so weigh it against the light on your landing.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.