Product code: ECK-LKS-010luxury steel door
Fırat Line-Textured Steel Door
Fırat covers almost the whole of its dark walnut-toned leaf with one long rectangular panel, worked across its surface with fine horizontal lines. The texture catches light at different angles rather than sitting flat, so the panel keeps moving as you pass it. A small viewer sits above the panel, and two separate lock cases stand apart on the left edge rather than being stacked together.
- Door leaf
- Single leaf
- Glazing
- No
- Hardware
- Gözetleme deliği
- Door frame inner size
- 90 x 200 cm
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
A wide plain frame runs round the textured panel and is left bare on purpose, so the eye has somewhere to rest before it meets the lined surface. The horizontal lines inside the panel read wider than the leaf actually is, which is why Fırat sits comfortably even in a narrow stairwell landing.
The panel's proportion is set against the height of the leaf; on a shorter door the line count comes down while the spacing between lines stays the same. The dark walnut tone holds its own against a landing finished in almost any colour.
The two separate lock cases read as a fuller locking line at the entrance, which adds a further sense of security to the doorway.
- Fine horizontal-line texture on a single long panel
- Two separate lock cases
- Wide plain frame
- Round viewer
- Single leaf, no glazing
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LKS-010 |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Gözetleme deliği |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Fırat Line-Textured Steel Door?
Fırat covers almost the whole of its dark walnut-toned leaf with one long rectangular panel, worked across its surface with fine horizontal lines. A small viewer sits above the panel, and two separate lock cases stand apart on the left edge, so the door does not rest on a single locking point.
Can the Fırat Line-Textured Steel Door be made to a custom size?
Yes. This model is prepared to a standard frame opening as stock. Where your opening differs, the long lined panel, the twin lock cases and the wide plain frame carry over and the door is produced to your measurement. Send the width and height taken from inside the frame; our team retakes the measurement on site before manufacture.
Which group does the Fırat Line-Textured Steel Door belong to?
Fırat sits in the luxury steel door group with a single leaf, no glazing and a round viewer. The body, insulation and lock hardware are shared across the group; what changes from one model to the next is the surface design, the facing and the leaf layout.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.