Product code: ECK-LKS-058luxury steel door
Patika Geometric Inlay Steel Door
Patika carries a distinctive path-like pattern down the right edge of its golden oak-toned leaf, built from pale inlaid lines in alternating diamond and square shapes that link together vertically. These geometric shapes, chained one after the other like links, throw a strong contrast against the dark black surround and the lighter timber ground.
- Colour
- Ahşap tonu
- Door leaf
- Single leaf
- Glazing
- No
- Hardware
- Bar kulp
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
While the inlaid line runs down the right edge, a plain black bar handle on the left balances the composition, and a small viewer sits above. The inlaid line travels only a narrow strip down the right edge, so it gives the door its pattern while leaving most of the oak ground open.
The pattern's length stretches with the height of the leaf; because we keep the diamond-and-square sequence unbroken, the pattern always finishes on a complete repeat. The pairing of the black surround and the golden oak ground gives the entrance a modern, graceful balance.
That path-like line sets the door apart with a distinctive signature, clear of the panel layouts the rest of the collection relies on.
- Vertical inlaid diamond-and-square chain pattern
- Golden oak timber-grain ground
- Black surround frame
- Vertical black bar handle
- Single leaf, no glazing
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LKS-058 |
| Colour | Ahşap tonu |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Bar kulp |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Patika Geometric Inlay Steel Door?
Patika carries a path-like pattern down the right edge of its golden oak-toned leaf, built from pale inlaid lines in alternating diamond and square shapes that chain together vertically. These linked geometric shapes throw a strong contrast against the dark black surround and the lighter timber ground.
Can the Patika Geometric Inlay Steel Door be made to a custom size?
Yes. This model is prepared to a standard frame opening as stock. Where your opening differs, the inlaid diamond-and-square pattern, the golden oak ground and the black surround carry over and the door is produced to your measurement. Send the width and height taken from inside the frame; our team retakes the measurement on site before manufacture.
Which group does the Patika Geometric Inlay Steel Door belong to?
Patika sits in the luxury steel door group, finished in black with a single leaf, no glazing and a bar handle. The body, insulation and lock hardware are shared across the group; what changes from one model to the next is the surface design, the facing and the leaf layout. Weigh the light at your entrance before choosing.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.