Product code: ECK-LMK-009Laminoks steel door
Pano Block-Composition Laminoks Steel Door
Pano splits an anthracite ground into rectangular blocks of uneven size and sets small terracotta areas between them. No two blocks share a size, and none of them line up into a grid.
- Colour
- Antrasit
- Surface finish
- Laminoks
- Door leaf
- Single leaf
- Glazing
- No
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
The irregularity is deliberate: an even grid would sit still, while a run of mismatched blocks keeps the eye moving across the surface. The leaf is not meant to be read in a single glance; it asks for a moment longer.
The terracotta areas take up only a small share of the whole surface, and that restraint is what holds the composition together. Spread any wider, the accent colour would overpower the anthracite ground and the balance would tip.
The black handle sits outside the blocks, at the left edge. It stays apart from the composition rather than joining it.
The terracotta accent can be swapped for mustard, petrol blue or olive green over the same anthracite ground; the proportion of the accent area stays fixed, only the colour changes.
- Anthracite Laminoks ground
- Uneven rectangular block division
- Terracotta accent areas
- Black vertical bar handle
- Single leaf, unglazed
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LMK-009 |
| Colour | Antrasit |
| Surface finish | Laminoks |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Bar kulp, Mermer eşik |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Pano Block-Composition Laminoks Steel Door?
Pano breaks an anthracite ground into rectangular blocks of uneven size, with small terracotta areas set between them, and none of the blocks line up into a grid. The mismatch is deliberate: an even grid would sit still, while this arrangement keeps the eye moving across the leaf rather than reading it in one glance.
Can the Pano Block-Composition Laminoks Steel Door be made to measure?
Pano is prepared to a standard frame opening as stock. For a different opening, the same anthracite ground, block division and terracotta accents are kept and the leaf is made to measure. Send the width and height taken from inside the frame; the opening is rechecked on site before fitting.
Which group does the Pano Block-Composition Laminoks Steel Door belong to?
Pano sits in the Laminoks steel door group, in anthracite with a single unglazed leaf and a black bar handle. Body, insulation and lock hardware are shared across the range, and the facing is the point of difference, so weigh it against your landing's light and the width of the entrance.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.