Product code: ECK-LMK-013Laminoks steel door
Taflan Twin Timber Panel Laminoks Steel Door
Taflan sets two timber panels side by side inside an anthracite frame, with a narrow vertical strip between them carrying a chrome handle.
- Colour
- Ahşap tonu
- Surface finish
- Laminoks
- Door leaf
- Single leaf
- Glazing
- No
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
The two panels are not equal in width: the left is narrow, the right is wide. That imbalance stops the leaf reading as symmetrical and naturally draws attention to the narrower side, where the handle already sits; the eye goes there anyway.
Both panels carry the same horizontal line texture in the same tone. Without the strip between them they would read as one continuous surface; the narrow division is enough to keep the two areas distinct.
Resting the chrome handle on the dividing strip keeps hand contact off both the timber and the anthracite. Since that area wears fastest, this placement protects the surface over a longer stretch of use.
- Anthracite frame
- Two timber panels with horizontal line texture
- Narrow vertical strip between panels
- Chrome bar handle on the dividing strip
- Single leaf, unglazed
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LMK-013 |
| Colour | Ahşap tonu |
| Surface finish | Laminoks |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Bar kulp, Mermer eşik, Krom detay |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Taflan Twin Timber Panel Laminoks Steel Door?
Taflan places two timber panels side by side inside an anthracite frame, with a narrow strip between them carrying a chrome handle. The panels are unequal in width, narrow on the left and wide on the right, and that imbalance naturally draws the eye to the narrower side where the handle sits.
Can the Taflan Twin Timber Panel Laminoks Steel Door be made to measure?
Taflan is prepared to a standard frame opening as stock. Where your opening differs, the same anthracite frame, twin panels and dividing strip carry over into a made-to-measure leaf. Send the width and height taken from inside the frame; the opening is rechecked on site before fitting.
Which group does the Taflan Twin Timber Panel Laminoks Steel Door belong to?
Taflan stands in the Laminoks steel door group, in a timber tone with a single unglazed leaf and a chrome bar handle. Body, insulation and lock hardware are shared across the range, and the facing layout is the point of difference, so weigh it against your landing's light and opening width.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.