Product code: ECK-LMK-008Laminoks steel door
Alabaster White-Banded Laminoks Steel Door
Alabaster sets a narrow white vertical band along the left edge of a plain anthracite ground and gathers a group of fine horizontal lines into the lower section of the leaf.
- Colour
- Beyaz
- Surface finish
- Laminoks
- Door leaf
- Single leaf
- Glazing
- No
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
The top two-thirds of the composition are left entirely bare, and that emptiness is itself the design: with the pattern gathered low, the leaf's visual weight sits near the floor and the door reads as sturdy. A pattern spread across the top would make the leaf look top-heavy instead.
The white band is kept narrow on purpose. Widened, it would cut the leaf in two; held at this width it reads instead as a line of light drawn across the anthracite ground.
The chrome handle sits immediately to the right of the white band. Two pale elements placed side by side mark out where the door opens, visible even from a distance.
- Anthracite plain Laminoks facing
- Narrow white vertical band on the left
- Horizontal line group in the lower section
- Chrome vertical bar handle
- Single leaf, unglazed
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LMK-008 |
| Colour | Beyaz |
| Surface finish | Laminoks |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Bar kulp, Mermer eşik, Krom detay |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Alabaster White-Banded Laminoks Steel Door?
Alabaster runs a narrow white band down the left edge of a plain anthracite ground and gathers a group of fine horizontal lines into the lower section of the leaf. Leaving the top two-thirds bare is deliberate: the pattern's weight sits low, which keeps the whole door reading as sturdy rather than top-heavy.
Can the Alabaster White-Banded Laminoks Steel Door be made to measure?
Alabaster is prepared to a standard frame opening as stock. Where your opening differs, the same anthracite ground, white band and lower line group carry over into a made-to-measure leaf. Pass us the width and height from inside the frame; the opening is measured again on site before fitting.
Which group does the Alabaster White-Banded Laminoks Steel Door belong to?
Alabaster stands in the Laminoks steel door group, in white with a single unglazed leaf and a chrome bar handle. Body, insulation and lock hardware stay common across the range, and the facing layout is the real difference between models, so weigh it against the light your entrance gets.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.