Product code: ECK-OZP-001one-off project door
Spinel Red-Framed Gloss Black Project Door
Spinel sets a gloss black leaf inside a red frame and runs a red wave-shaped band across the leaf. The band is not straight; it curves as it falls from top to bottom.
- Colour
- Siyah
- Hardware
- Mermer eşik
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
Colour has no fixed limit in the project range; leaf and frame can be chosen independently of each other. This model is the furthest point of that freedom: there is no middle tone between the two colours, the contrast is set directly.
The gloss black surface is reflective. The colour of the opposite wall, the light on the landing, even a passer-by shows up in the door, which is why this model tends to be chosen for wide, well-lit entrances.
Project doors are always produced to the measurement of the opening. A non-standard opening is not a problem; the measurement taken at survey becomes the manufacturing measurement and the leaf is cut to the opening.
- Red frame
- Gloss black leaf
- Red wave-shaped band
- Black horizontal handle
- Produced to the opening measurement
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-OZP-001 |
| Colour | Siyah |
| Hardware | Mermer eşik |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
This model is made to the measurement of your door opening, not to a stock size. Measure the width and the height from inside the door frame and send them over; write down the wall thickness as well.
Frequently asked about this model
What kind of door is the Spinel Red-Framed Gloss Black Project Door?
Spinel sets a gloss black leaf inside a red frame and runs a curving red wave-shaped band across it. Leaf and frame are chosen independently in the project range, and this model takes that freedom furthest: there is no middle tone between the two colours, the contrast is set directly.
Can the Spinel Red-Framed Gloss Black Project Door be made to a custom size?
This model is not kept to a stock size; it is produced to match the measurement of your door opening. Where your opening is non-standard, the same red frame, gloss black leaf and wave-shaped band carry over and the door is built to that measurement. Send the width and height taken from inside the frame; our team retakes the measurement on site.
Which group does the Spinel Red-Framed Gloss Black Project Door belong to?
Spinel sits in the one-off project door group, finished in black with a marble threshold. The body, insulation and lock hardware are shared across the whole catalogue; what changes from one model to the next is the surface design, the facing and the leaf layout. Weigh the light at your entrance before choosing.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.