Product code: ECK-KMP-004composite steel door
Vega Diagonal-Line Composite Steel Door
Vega breaks a plain anthracite ground with nothing more than three fine chrome lines running on the diagonal, splitting the leaf into triangular fields of unequal size.
- Colour
- Antrasit
- Surface finish
- Kompozit
- Door leaf
- Single leaf
- Glazing
- No
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
It's the plainest model in the range. There's no panel, no texture, no second colour: the whole effect comes from the angle of the lines. A horizontal or vertical division would have settled the leaf down; running the lines on the diagonal does the opposite and builds in tension.
That plainness pays off in use too: there's no recess or ridge to collect dirt, so the surface wipes clean in one pass. That's part of why we suggest this model for a heavily used apartment entrance.
The handle is long and black and sits at the left edge, where the lines run out. It stays outside the composition rather than inside it, bounding the pattern instead of joining it.
With only three lines carrying the whole design, their thickness matters. A heavier line would break the leaf up and undo the simplicity; kept this fine, the pattern reads as though it were drawn straight onto the surface.
- Anthracite-grey composite surface
- Fine diagonal chrome lines
- Leaf divided into triangular fields
- Long black vertical handle
- Unglazed single leaf
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-KMP-004 |
| Colour | Antrasit |
| Surface finish | Kompozit |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Mermer eşik, Krom detay |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What makes Vega different from the other composite models?
Vega is the plainest surface in the range: a flat anthracite ground crossed by just three fine chrome lines, run on the diagonal rather than straight, which splits the leaf into triangular fields of unequal size. There is no panel, texture or second colour competing with the lines.
Does the plain surface make Vega easier to keep clean?
Yes. Because there's no raised panel or recessed texture, there's nothing for dirt to sit in, and the leaf wipes clean in a single pass. That's one reason we suggest it for an apartment entrance that gets heavy daily traffic, where a more textured surface would need wiping more often.
Can Vega be made to a non-standard opening?
Yes. The three diagonal lines and their angle are kept exactly as drawn; only the leaf and door frame dimensions are reworked to fit your opening. We take the measurement on site before manufacture starts, since the line angle has to be redrawn against the new leaf size, not just scaled up.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.