Product code: ECK-LMK-004Laminoks steel door
Aytaşı Vertical-Line Panelled Laminoks Steel Door
Aytaşı drops a white, vertically lined panel into the middle of an anthracite ground, with a thin black strip running along one side of the panel to close off the composition.
- Colour
- Antrasit
- Surface finish
- Laminoks
- Door leaf
- Single leaf
- Glazing
- No
You do not need to type the code, we see it when you arrive from the link. We send the measurement and the delivery time in writing.
On-site measurement
The frame opening and the swing direction are settled at your address.
Manufacture and installation
Manufacture to your measurement, removal of the old door and installation in one run.
Checked after installation
Lock and hinge adjustment are checked once the door is in.
What this model has
The white panel is the brightest point on the leaf, and the eye goes there first. It is the anthracite ground that sets up that contrast; on a pale ground the same panel would fade in and the leaf would read as a single flat colour.
The panel runs vertical lines against a ground of horizontal ones, and the pairing keeps the two textures distinct. Run in the same direction, the boundary between them would blur and the panel would look like a continuation of the ground rather than an element in its own right.
A pale surface carries a known cost: marks and dust show sooner than they would on a darker tone. Here the panel sits away from the handle and takes no hand contact, which in practice removes most of that concern.
- Anthracite horizontal-line ground
- White vertical-line centre panel
- Black strip beside the panel
- Black vertical bar handle
- Single leaf, unglazed
- Marble threshold
Attributes
| Item | Value |
|---|---|
| Product code | ECK-LMK-004 |
| Colour | Antrasit |
| Surface finish | Laminoks |
| Door leaf | Single leaf |
| Glazing | No |
| Hardware | Bar kulp, Mermer eşik |
| Door frame inner size | 90 x 200 cm |
| Architrave outer size | 108 x 210 cm |
| Item | Value |
|---|---|
| Steel body | 2 mm Ereğli A1 steel |
| Insulation core | 150 kg/m³ rock wool |
| Lock system | Kale 256G, 14-point |
| Certification | TSE EN 1627 |
The values below are the same across every model in the catalogue. What separates the models is the surface design, the finish and the way the door leaf is built.
Every model carries a warranty as standard. On upper-tier models an extended warranty applies, depending on the material chosen.
Measurements
Inside the door frame (the door opening): 90 x 200 cm · Architrave edge (outside the door frame): 108 x 210 cm. If your door opening falls outside these measurements, the same model is made to your size.
Frequently asked about this model
What kind of door is the Aytaşı Vertical-Line Panelled Laminoks Steel Door?
Aytaşı sets a white, vertically lined panel into the centre of an anthracite ground, with a thin black strip closing one edge of it. The dark ground is what makes the panel read as the brightest point on the leaf; on a pale ground the same panel would simply disappear into it.
Can the Aytaşı Vertical-Line Panelled Laminoks Steel Door be made to measure?
Aytaşı leaves the workshop at a standard frame size as stock. Where your opening differs, the same anthracite ground, white panel and black strip transfer onto a made-to-measure leaf. Give us the width and height measured from inside the frame; the opening is rechecked on site before fitting.
Which group does the Aytaşı Vertical-Line Panelled Laminoks Steel Door belong to?
Aytaşı stands in the Laminoks steel door group, finished in anthracite with a single unglazed leaf and a black bar handle. The body, insulation and lock hardware are shared across the range; the facing and its layout are the real variable, so weigh the light on your landing and the width of the opening before deciding.
Districts we install in
The catalogue is independent of area; for installation and service, move to the page for your own district.